-
Hello,
I had a long print fail last night after the filament reloaded plugin kicked in.
The plugin did it's job, paused and ran the M600 command when the filament ran out. However, I guess it sto…
-
This was always a lurking issue due to the following command in webcam_stream.py
```sarge.run('sudo service webcamd stop')```
However, until version 2.3.3, the return code was not checked and the …
-
Make all fancy like. With lots of cats and octopi!
orias updated
9 years ago
-
Here is link to video comparison (2016) of Octopi and Pamac - https://www.youtube.com/watch?v=e0crhf0kswo
-
good evening everyone.
I tried to create RPI 5 pinn images for OctoPi, Repetier-Server and OpenMediaVault.
Unfortunately, this doesn't work and they are not yet available online. Have you ever d…
-
### The problem
I just did a couple of retract tests which should use ~ 2g of filament.
I aborted a couple of them and just afterwards I noticed that my spool weight dropped down from ~900 g down t…
-
**Describe the bug**
A clear and concise description of what the bug is.
New install of OctoPi 1.0.0 with OctoPrint 1.8.7 after apt update and upgrade, the installation finish successfuly but the ap…
-
I keep getting an error when trying to use "Print to OctoPrint"... when I go into the machine settings, it says, "OctoPrint is not available:. But if I click "open in web", it open's right up. And i…
-
I was not able to install plugin on updated OctoPrint v 1.3
Part of error log is the following
Building wheels for collected packages: cryptography, cffi
Running setup.py bdist_wheel for cr…
-
Hi there!
My first post on github :-). I stumbled over a problem during update while reading my OctoPi log (OctoPrint 1.3.12 running on OctoPi 0.16.0)
[octoprint.log](https://github.com/derpicknic…