-
Hi,
I am writing an article on using the Snap! to program with the Raspberry Pi's GPIOs. I have borrowed heavily from your code, so I owe you some hearty thanks for that. If you would like to take a …
ghost updated
10 years ago
-
```
What steps will reproduce the problem?
1. brows trough phpmyadmin
What is the expected output? What do you see instead?
Ports that are turned on will turn off for a short time. But enough time t…
-
```
What steps will reproduce the problem?
1. brows trough phpmyadmin
What is the expected output? What do you see instead?
Ports that are turned on will turn off for a short time. But enough time t…
-
This is a great package but I wanted to try it without hooking anything to the GPIO connector - so I added audio output through the Raspberry Pi audio jack. It clicks like crazy but it works:
ht…
-
```
What steps will reproduce the problem?
1. brows trough phpmyadmin
What is the expected output? What do you see instead?
Ports that are turned on will turn off for a short time. But enough time t…
-
```
What steps will reproduce the problem?
1. brows trough phpmyadmin
What is the expected output? What do you see instead?
Ports that are turned on will turn off for a short time. But enough time t…
-
```
What steps will reproduce the problem?
1. brows trough phpmyadmin
What is the expected output? What do you see instead?
Ports that are turned on will turn off for a short time. But enough time t…
-
Is there a diagram for where the connectors go on the Pi's GPIO?
-
Creating issue to capture change points necessary for upgrading to Raspberry Pi 5/Bookworm
-
Hi,
I prepared openwrt image including node packets in these repo. But I cannot control GPIO and serial ports over Node-Red, it gives error on debug windows when I deploy the script on Node-Red wit…