-
Mesh data gets further and further off with each probing.
Mesh data should be reset between probing.
**Debug Log**
**Screenshots**
**Firmware and Version**
Marlin 2+bugfix
I had an …
-
So first my setup. I've got a BTT SKR 1.4 Turbo Board and a RPi 3b+ connected via USB running latest OctoPrint, FirmwareUpdater ist configured to upload via Serial Transfer Protocol. I've updated the …
-
### Bug Description
When setting negative Z-Values with `M851` e.g.: `M851 z-5`
the response to `M851` is correct, but the printer acts like it was set to `0`
### My Configurations
- Marlin 2.…
-
klipper uses standard trapezoid acceleration as far I know. I never seen a firmware with s-curve like acceleration and I think it would work better for printers
Some video from https://www.youtube.co…
-
[Marlin.zip](https://github.com/MarlinFirmware/Marlin/files/4996866/Marlin.zip)
### Bug Description
ESP3D_WIFISUPPORT Does not work
Error message produced
Log Output
```
Processing LPC…
-
Bought diy kits and installed on Geeetech a10 (printer similar to ender3 ). Calibrated and installed according TEaching tech video. Drivers in closed loop mode misbehave.. they count steps as red led …
-
Hi, I am using the latest firmware release (3.1.1-14) on my SKR 1.4 Turbo with DuetWebControl Version 3.1.1.
I flashed an ESP8266 with the latest release of Duet WiFi Socket Server for LPC1768 versio…
-
I have recently fitted a BTT SKR 1.4 Turbo motherboard to my printer.
I’ve got everything working except for the Part Cooling fan which doesn’t turn when needed.
I’m using Marlin 2.0. Bu…
-
# Problem Report
## Describe the Issue
I am trying to use the heated bed MOSFET outputs to turn on and off the vacuum pump based on a pressure sensor. This is all working well, however, I would also…
-
Ciao a tutti è ormai da giorni che provo a configurare Marlin v2.0.7.2 con mainboard SKR 1.4 turbo
ho problemi sempre con le stesse cose
i motori sono TMC2208
questo è quello che mi spunta
PS C…