-
The current hull weight calculation is broken. Problems:
1. It uses at least two arbitrary calculation parameters that should be calculated from hull geometry: Cb_design and LWL_design. They could bo…
-
Do we want to prevent or at least warn about duplicate uploads? E.g. check some hash, and if it's really the same, then at least warn the user before committing the upload?
-
When i select a Bending Detail Schematic and preform a Snoop Selection Revit crashes.
Below a fragment of the journal where i think the crash hapens. (if needed i can send the full journal).
' …
-
As discussed in #297, adding overloads for passing maps around manually is not a good solution for increasing observability, though was helpful in the short run.
What would an ideal interface for d…
haved updated
9 months ago
-
I want to couple the SPH and finite element menthods by using DualSPHysics and Chrono.Whether it can be successful or not？What literature can I refer to？
Thanks in advance!
-
Correction needed for raw affiliation Electromechanical Engineering, ENSAM Meknes, Moulay Ismail University, Marjane 2, Meknes 50000, MOROCCO.; Laboratory of Innovation and Systems Engineering ; Mec…
-
Correction needed for raw affiliation Electromechanical Engineering, ENSAM Meknes, Moulay Ismail University, Marjane 2, Meknes 50000, MOROCCO.; Laboratory of Innovation and Systems Engineering ; Mec…
-
Correction needed for raw affiliation Electromechanical Engineering, ENSAM Meknes, Moulay Ismail University, Marjane 2, Meknes 50000, MOROCCO.; Laboratory of Innovation and Systems Engineering ; Mec…
-
Correction needed for raw affiliation Electromechanical Engineering, ENSAM Meknes, Moulay Ismail University, Marjane 2, Meknes 50000, MOROCCO.; Laboratory of Innovation and Systems Engineering ; Mec…
-
Correction needed for raw affiliation Electromechanical Engineering, ENSAM Meknes, Moulay Ismail University, Marjane 2, Meknes 50000, MOROCCO.; Laboratory of Innovation and Systems Engineering ; Mec…