-
I tried this sniffer and it works just fine.
My question is:
If I get say, this line in the output buffer
`S0100000W+00001000+s`
I can see that on the 0100000 address I have 00001000 data. How t…
-
SOC
ESP32
Lora IC
LILYGO LORA32 868/915MHz
Description
I am trying to figure out why the GPS module is not working.
I already tested the GPS reset and test firmware and the NMEA reset.
…
-
### Checks
- [X] I agree to follow the MicroPython [Code of Conduct](https://github.com/micropython/micropython/blob/master/CODEOFCONDUCT.md) to ensure a safe and respectful space for everyone.
- [X…
-
Thanks for the development!
But I need help...
I have a Lora Lilygo T3 V1.6.1 and no matter how much I follow your tutorial I can't flash this :/
I know I shouldn't put this here, but I don't know …
-
I have been doing some testing to determine when I'm no longer connected to a gateway... The goal is to determine when I need to try a rejoin??
I start off with an active GW, I do join the network,…
-
Hello, I made a RPC project in esp-idf, but it did not work. He showed me that he was subscribed to the RPC, but I got no response from the terminal when I sent an RPC from Thingsboard. but when I res…
-
After flashing the latest firmware onto the LilyGo T-Beam, everything appears to work correctly. After power loss, the device doesn't seem to boot up at all. rnodeconf classifies as missing.
The on…
-
### Category
Hardware Compatibility
### Hardware
T-Lora v2 1.6
### Firmware Version
2.3.9.f06c56a
### Description
Device: T-LoRa V2.1-1.6
Firmware: 2.3.9.f06c56a Alpha
Error: …
-
I'm trying to compile a simple test that just receives data in a loop using ESP-IDF (code shown below).
The build fails with the following error:
```
In file included from /home/kjartan/Documents…
-
Hi, just getting into this with the hope of getting my ecowitt temperature / humidity sensors recognized.
I have this working with the regular rtl_433 code and an SDR, albeit with a small mod to `f…