-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
Stepper motors are noisy/vibrate at low, medium and high speeds (30mm/s, 60mm/s, 80mm/s, 120mm…
-
Hi, i wrote a sketch using your library on an Arduino Nano while waiting for an ESP32 to arrive, but when i tried to upload that sketch to the ESP32, VSCode threw an error that your library only suppo…
-
Hi,
I had an SKR PRO V1.2 recently. I tried to configure it using Marlin in this repo. I could not get it working. Then I switched to the Marlin repository (https://github.com/MarlinFirmware/Marlin…
-
I'm going to receive a Re-Arm in the next few days, replacing my RAMPS Atmega2560 Setup. From my Research so far there shouldn't be an issue to run my TMC2130 in SPI, the question is about the TMC2208…
-
Followed the guide for editing Marlin 2.0 for the SKR mini E3 V1.2, but when I try and hit CTRL+ALT+B I get STM32F103RC_bigtree FAILED.
Not sure if this matters but noticed when pasting in
` #def…
-
I recently bought an SE Plus and their duel z kit. Now I complied the FW to accomplish a few things.
- activate auto z-align
- activate the second z motor and the TMC 2209 driver that came with…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
When using MKS_UI (TFT_LVGL_UI) there are Y axis motion losses / offsets at random Z heights,…
phcay updated
4 months ago
-
I just imaged my FLSUN QQS pro with the 2.1.2 firmware. When i try to access the SD card i have to hit refresh multiple times then when the files load i can select them but nothing prints. It doesnt s…
-
**English:**
Hi there,
I really have to praise the development work here.
I have an I3 Mega.
However, I noticed the following with Mesh Bed Leveling.
Recently I have done the Mesh Bed Level…
-
Hello
I got annoying problem with random moires?? on my internal and externall walls.
- Tried reflashing firmware
- Replaced stepper drivers to be sure thats not the tmc2208 fault. (tried on dr…