-
Sir, today i started assembling my printer'
first connected Filament sensor to port DLJC, but led in that filament sensor is not glowing
then i checked voltage of pins with multimeter , getting 3.3V…
-
Hello,
I've found no way to get this board working with dual Z driver and dual Z endstop.
The second Z driver (Z2) was recognized, but the endstop resource never be used.
My actual configuration …
-
Hi
I am getting
**Unable to write tmc spi 'stepper_x' register GLOBALSCALER**
error when I try to home steppers on SKR 3 EZ, using EZ5160 drivers
below is my printer.cfg config, pretty standard…
-
On the board that I designed and uses stm32F4 there are 3 spi hardware.
The TMC2130 that I use are connected to a dedicated spi hardware.
The TMCStepper library relies on the software spi or the Ard…
-
I received an email asking about TMC2209 drivers in UART mode. I thought it best to move the conversation to a more public space so that the collective wisdom of the open source community can be harne…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Hello
I have a five motors 17HS4401 with TMC2209 on scr 1.4. All motors operate correc…
-
**Describe the bug**
Rightly or wrongly, the compile_commands.json file is being created with both unix forward slash, and escaped windows backward slash.
if you tell me that the bug is further upch…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
This is a known issue, first reported here: #23248 This Tickets has then be closed automatica…
-
Hi,
I am using your lib in my Project: https://groups.io/g/TeenAstro/wiki/home
Your are mentioned has contributor 🥇
Many user has requested servo motor support. Trinamic has a board that is int…
-
Hello , did somebody tried to use this library as motion controller mode.
Meaning that sending speed and destination via SPI and chip has full control motor ?
thanks a lot.