-
Affected device with corresponding switch chip:
- ASUS RT-AC58U: Qualcomm Atheros QCA8075
- ASUS RT-AC85: MediaTek MT7621
- Linksys AX3200: MediaTek MT7531BE
- Xiaomi Mi Router 3 Pro: MediaTek MT7…
-
### systemd version the issue has been seen with
systemd 254.1-1
### Used distribution
Archlinux
### Linux kernel version used
6.4.12-arch1-1
### CPU architectures issue was seen on
None
### C…
-
There are two issues when injecting control frames (RTS/CTS) to an ath9k-htc interface in monitor mode:
1. CTS packets are truncated and malformed
2. The unicast control frames are always re-trans…
-
Options: Settings->Wi-Fi Access Point Setup->Enable AP Mode
Don't Work - Cant disable "AP mode".
Please help - how to disable AP.
When i Unchecked "Enable AP Mode" - wifi AP still working!
I don't…
-
This is a placeholder issues to document findings on power save on T & N
T & N devices have a power save mode, but currently we don't enter it.
Power save mode has been shown to be able to enter…
-
During boot of the board I always get this error message:
```
notice: wlan0: link state changed to UP
err: wlan0: ipv4_addroute: File exists
```
-
First of all, I would like to thank you for developing and providing this integration. It works excellently.
I would like to operate the device only in the local network. I don't want my data to be…
-
* [ ] IT-Security
-
Using WILC1000 with WILC Firmware Ver = WILC_WIFI_FW_REL_15_3_1 Build: 11736 on custom built Yocto linux.
While attempting to send a 150MB from a PC to a device with the WILC1000, the transfer stop…
-
Hi,
Our base hardware is a beaglebone running 4.19.94-ti-r42 kernel, and our 8188eu device is as follows:
root@beaglebone:/opt/rtl8188eu# lsusb
Bus 001 Device 003: ID 0bda:8179 Realtek Semiconduc…