-
I have a TI CC2531 USB CDC plugged in (with pre-flashed firmware), both dmesg and lsusb show the device., but whsniff says "ERROR: No working device found."
Ubuntu 22.04.04 LTS
I think not rela…
-
### What happened?
I moved to SLZB-06P7 over ethernet and removed the zigbee stick on /dev/ttyUSB0 from the configuration. Z2M is installed over docker.
docker-compose.yaml:
zigbee2mqtt:
c…
-
@slaesh Do you have any plans to make and sell a CC2652P version of your Texas Instruments CC2652 USB dongle adapter?
* CC2652P = CC2652R with a built-in RF PA (Power-Amplifier) capable of +20 dBm …
Hedda updated
3 years ago
-
# Zigbee LED controller dimmer (GL-C-009) Gledopto 10-15s delay to switch off and unable to read states from Home assistant .
I have two GL_C-009 ( led salone - Led cucina ) with Hassio v. 0.1…
-
Hi!
Thank you for such a great project! I'm trying to run the [example](https://github.com/luar123/zigbee_esphome/blob/master/example_esp32c6.yaml) on ESP32-C6 but I get error that `Network steering …
-
Hi Chris,
The README says more work is required for ConBee and RaspBee. Would you mind creating a list/issue here with details?
I'd like to help!
Thanks
S
-
### What happened?
I have an Acova Taffetas2 heater Zigbee Model TAFFETAS2 D1.00P1.01Z1.00
It appears as supported in Zigbee2MQTT and exposes three system modes: "off", "auto" and "heat".
Bu…
-
### Problem description
I try to pair a LIDL Device (Silvercrest SAPZ A2 : a new version sold in France with power consumption measuremenst of the SAPZ A1 which already works well with ZHA) .
During…
-
Dear,
I've followed your instructions & was able to build & run OK the binary in an Ubuntu 20.04 64 bits (please see log @the end)
I've also flashed the dongle exactly with the same version you used…
-
### What happened?
Dear community,
I have an Aqara Smart Plug SP-EUC01 and I have noticed that my aqara smart plug EU (rated for 2300w) is blinking blue/red (slow) after a couple of minutes under …