-
Hi . I wired everything like shown up but get TMC Connection Error in Display. Checked via Pronter 3 TMC2008 get a Connection But the 4. Has bad Response All to low. Can sw Help pls . I used BT…
-
### Description
### Steps to reproduce
1. New firmware installed
2. click motion
3. click auto home
4. printer homes x and y
5. printer moves nozzle to center of bed and begins descend…
-
I use EBBSB 2209 ，how to solve it
Transition to shutdown state: TMC 'extruder' reports error: GSTAT: 00000001 reset=1(Reset)
-
### Description
CR-Touch doesnt Auto home properly using the marlin firmware.
I already tried adjusting some settings in the firmware.
defining USE_PROBE_FOR_Z_HOMING and BLTouchv
### S…
Loifu updated
7 months ago
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Apparently since March, when `MULTISTEPPING_LIMIT` was added and **module/stepper.cpp |…
-
Hello Biqu team, I have a B1, just received the microprobe V2 and it is very difficult for me (and a looot of people) in order to edit the firmware to accept the microprobe V2 firmware modification ne…
-
Hi! im trying connect btt exp mot with tmc2209 for a 2 x carriage but give me a error, need a tx and rx pin? please have any tutorial? thanks
-
### Did you test with a precompiled firmware?
Yes, and the problem still exists.
### Bug Description
I'm writing here to maybe get some additional troubleshooting on this particular issue.
I hav…
-
### Is your feature request related to a problem? Please describe.
_No response_
### Are you looking for hardware support?
_No response_
### Describe the feature you want
There are many 4-axis bo…
-
I've been talking with @Fragmon a bit about their Kobra work today and an interesting find came up: Bltouch probes don't work with the clock speed set to 200mhz. Flashing a 200mhz config shows a 168mh…