-
### Question
I'm currently in despair. I'm now trying to set up a Zigbee device with my ESP32 C6 for my mailbox project, which is currently still running via WiFi and MQTT and I would like to repla…
-
So Omnithing works beautifully. Nice! Google home will pull in the temp from a DHT11 but the other child device humidity will not. I can see the values in ST. Is this just a limitation of Google Ho…
-
Hi,
on my Raspberry Pi 3 Model B Rev 1.2, with four DHT11 sensors connected, I need to increase the delay while reading the sensor to (at least) 2 microseconds (delayMicroseconds(2); in DHT11.xs, L…
-
Hello John,
I connected a DHT11 sensor to my ESP32. The sensor will not be found.
I checkt the signals with the Oszilloskop.
The SW is doing the Pulldown but it is a little bit short. In the sp…
-
@kirovilya Any chance you be willing to add support for any more popular environmental sensors?
I guess that the most popular in demand in this specific case would be the sensors that ITead alread…
-
Thank you for opening an issue on an Adafruit Arduino library repository. To
improve the speed of resolution please review the following guidelines and
common troubleshooting steps below before cre…
-
Hello, I am trying to use DHT11 to match your cool library to complete the temperature display. I found that the official DHT11 library cannot be used. I try to use the capture mode of the hardware ti…
-
mciropython need to support more device
-
**Describe the problem you have/What new integration you would like**
I managed to migrate my Sonoff basic devices from Tasmota to esphome. But facing issues with Sonoff sc. Initially I flashed s…
-
La placa utiliza una distribución de pines VCC, Data, GND. Algunos de estos sensores utilizan VCC, GND, Data.