-
I've spent hours working with FLSUN to fix the firmware for my custom QQ-S Pro with an MKS Robin Nano V3.1 and a TS35 V2.0.
I have the Homing fixed except, if I offset any axis by a small amount ma…
-
## Version of the custom_component
`5.2.0` 5b9f4f7738c8755c3958a002f7cadfd72244ca4d
## Describe the bug
Since ha `2024.4.4` the camera view does not work (now on `2024.5.1`. When I go to th…
-
### Basic Infos
- [x] This issue complies with the [issue POLICY doc](https://github.com/esp8266/Arduino/blob/master/POLICY.md).
- [x] I have read the documentation at [readthedocs](https://arduin…
-
I've tested this with my Cochlear Nucleus 7 processors, however, streaming seems to not be working, it disconnects almost instantly after connecting. I have tested this on both the right and left ear …
-
I was able to attach my PandaPi to my Openbeam Kossel Pro, and all that's left is configuration. However, whenever I run G33, it consistently errors out with either "homing failed" (if I don't home fi…
-
I have four sonoff mini diy. They were delivered with the 3.3.0 firmware release built in.
I managed to set diy mode (with jumper) and update tasmota firmware for three of them.
But when I connect…
-
I have images that I've put on a flash drive and then moved over to a Ubuntu machine that I then shrink them on (no errors). When I go to boot from cards burned from those images, I get nothing. There…
sborn updated
4 months ago
-
Hi,
Do you have plans for supporting the new range of BMS's from JK e.g. JK-PB1A16S10P?
-
aisler.net complains about this:
And indeed, one of those USB connector holes got electroplated,…
-
First install went well.
2 contact sensors detected and working 100%
1 motion sensor detected but not detecting motion.
...
I had created a full backup just before installing WyzeSense so I went …