-
Hi,
Would be asome if my tado thermostat (multizone) is visible for the EMS gateway.
Is there anyone willing to investigate the log?
Thanks!
-
Hi,
I have connected my EMS-ESP (an awesome EMS Bus Gateway Premium II (P2) from @bbqkees!) to my Worcester Bosch Greenstar 36CDi Compact Erp combi boiler with Comfort II RF wireless controller and "…
-
**Bug description**
Reading the damped outdoor temperature (thermostat) fails after a couple of hours.
After restarting its working again for some hours.
**Steps to reproduce**
Has been working…
-
I bought a EMS-E32 and upgraded the firmware to version v3.4.0b8 (the latest)
Started with SRT(hc1 selected room temperature) = 18 and HT (hc1 heat temperature) = 18.
Then I change the value of SRT …
-
**Bug description**
EMS_ESP 3.4.2
My problem is, that my Junkers installation doesn't have a room temperatur sensor connected. I don't know where the shown value is collected from. May be an ope…
-
-
Affected version: v3.4.4
Hardware:
Boiler | Condens 2500/Logamax/Logomatic/Cerapur Top/Greenstar/Generic HT3
-- | --
Thermostat | RC300/RC310/Moduline 3000/1010H/CW400/Sense 2
When…
-
System info see at end
Syslog shows
root@speicher:/var/log# grep -i 'No telegram' kern.log | sed 's/.*emsesp\] //' | sort | uniq
No telegram type handler found for ID 0x12 (src 0x10)
No …
-
-
**Bug description**
Home assistant spams the following message on every thermostat mqtt message when `thermostat_hc1_selected_room_temperature` goes to 30:
`[homeassistant.components.mqtt.number] …