-
Hi.
I have this panel:
![IMG_20210107_184541](https://user-images.githubusercontent.com/4441007/104048384-09db8080-51db-11eb-9dda-af7599edc451.jpg)
![IMG_20210107_184546](https://user-images.gith…
-
I have a 16x32 HUB75 Display running.
If I use the rainbow example (with original MATIRX_HEIGHT 32, MATRIX_WIDTH 64 and I compile the file - it works, I will see fancy color shades on the display
…
-
Hi
I'm working with ESP32 and 32*64 P5 panel with ICN2037BP chip. I'm trying to write simple HELLO message but it is not displayed properly. Same code works with FM6124 chip.
![WhatsApp Image 20…
-
Hi, I was red a lot of information about it, but I haven't any results.
My HUB12:
OE 1 2 A
N 3 4 B
N 5 6 F
N 7 8 S
N 9 10 L
N 11 12 R
N 13 14 F
N 15 16 F
I…
Czajo updated
6 years ago
-
Hi everybody.
I just bought a RGB Matrix Shield for ESP32 dev module with two diferent wirings: Smartmatrix and P3RGB64X32 (Neocat)
![2020-01-16T17_09_47 032Z-KIT-t2](https://user-images.githubuserc…
-
Considering a project to use this with a CM4 on a CM4IO board. This has its own +12V to +5V buck for the CM4 itself, but not enough power for the LED panels. So the panels need to be powered separa…
-
I recently bought a P2 128x64 LED panel with ICND2038S chipset. The HUB75 connector on it has pins for A, B and C but not D or E. Can I use the Adapter PCB to support drive just one LED panel and conf…
-
Good day and thank you in advance for such a great library and examples!
I had no issue with using the library with a single panel, as everything worked as expected. However, if I chain up a total…
-
Hi,
I recently purchased a P2.5 64x64 outdoor LED Panel https://www.aliexpress.com/item/1005005908894934.html
and the led-multiplexing doesn't seem to work for the 1/16 Scan.
I have an indoor P…
-
I have installed the library and followed the install for the adafruit software however when i run any code including the first demo, nothing is displayed on the matrix. the code runs fine with no err…