-
Miami Marlins vs Philadelphia Phillies played two games but the event id is the same
Market factory: "0x4225c4fe9a02706c7bec927a3db25f29e273b3d1"
market indexes: "493", "375"
these events shoul…
-
Would it be possible to include the jersey number of the pitcher and batter for each team? If you're only using a single 32x32 matrix then there's not enough room for the pitcher and hitter. But if it…
-
I'm using the bed_mesh feature and find it very useful. I have to check and calibrate my bed on a regular basis. I tried to enable bed tilt on top but I get an error "G-Code move transform already spe…
-
I have purchased a 3fxtrud 3d printer from a company called shapingbits a few months ago (prior to the kickstarter campaign). The printer uses marlin and i need to add additional extruders and change …
-
I know that Z-probe isn't really finished but I am trying to get bltouch working as normal endstop. With diffing it as servo I can control it, with command SET_SERVO SERVO=bltouch ANGLE=10 I can deplo…
-
Hello,
I recently purchased a RepRapDiscount full graphics smart controller (128x64 LCD Screen).
After uploading the Marlin 1.1.0-RC8 Firmware to the Arduino I noticed that the LCD starts to disp…
-
I have not been able to create a large print using this Marlin code without the printer just stopping in mid-print. The computer does not hang but the print job is ruined.
I patched the code (descri…
-
Hello, i have head that klipper don't step lock? i have noticed this bc i have a full metal printer that resonates like a mofo with klipper and not with marlin. atm i have it masked via dampers but it…
-
Looking for ways to avoid unnecessary delta kinematic calculations.
I know that Z_AXIS raw vs logical is used for home_offset, but are the X and Y workspace shifts EVER used for delta? If not I ca…
-
So, I noticed that someone has started adding Klipper to the [reprap wiki G-code page](https://reprap.org/wiki/G-code), but obviously from their point of view Klipper has a pretty minuscule feature se…