-
hi,
im trying to to connect two MPU9250 to ardinuo. I have been successfully been able to connect the both imu.
But im having trouble accessing the magnetometer reading from the imu. Im confuse how …
-
Hi,
I'm trying to use your lib with this board because the code given by the reseller is not working correctly.
I'm just starting arduino for this application and it is not as easy as I thought.
Do…
-
Hi
I'm trying to run an MPU9250's accelerometer at 4KHz and save it's values in a buffer while sampling other sensors on a lower frequency and then print the accelerometer buffer values along with ot…
-
I have only these pins on my mpu9250
VCC
GND
SCL/SCLK
SDA/SDI
EDA
ECL
ADO/SDO
INT
NCS
FSYNC
It shows device not found on serial monitor .
Please somebody help.
Thank you.
-
Hi Kris;
I connect two units of GY-91 (with one of the SDO connect to 3.3 V) to a mega2560 board, and use your MPU9250_BMP280_BasicAHRS_t3 code and only included the wire.h :
#include "Wire.h" …
-
I need to know if the MPU9250 I am using **will give me stable AHRS**. I am new to IMUs and I ask your opinion about my MPU9250(I am using the blue board). **Also I need to know what type of calibrati…
-
i try compile 12 ver of klipper ....... but error
Version: v0.12.0-102-g9f41f53c-dirty-20240206_175550-BTT-CB1
Preprocessing out/src/generic/armcm_link.ld
Linking out/klipper.elf
/usr/lib/gcc…
-
I try to read the value Who I Am from AK8963 in MPU9250, if I read the values of the accelerometer and the gyroscope in other skecth I have not problems, but When I try to configure the magnetometer f…
-
#### Description
How do we deal with sensors for which there is no specific sensor driver but that are working with an existing sensor driver? Examples:
- MPU9250 is working with MPU9150 driver
…
-
I am using the dual IMU code for MPU9250 with an ESP32 board. I have commented out the RTC related code and change IMU idetification ids to 0x73.
The second IMU is not detected when I run the code.
…