-
Hi, I'm trying to get into hc-11 data sets, some of the data were recorded by BZ64-6x10 probe. I'm quite confused how I could match the eeg data to the Probe Channels.
file='Achilles_10252013\Ach…
-
- [x] increase SMA openings in the front panel
- [x] increase fan fixing holes to 6mm
- [x] move large cap from the board edge to make more space for screws
- [x] move temp sensor connector from th…
-
First, I am running FW 098-336 STEM 14 as well OpenHPSDR Charly 25 rec 2017-07-20.
The I tried to use the IO-1, IO-2 and IO-3 from the Red Pitaya E1, that supposedly should control a preamplifier and…
-
Hi all
Running the commands below, we receive an error:
```
sysop@eida:~/tmp$
sysop@eida:~/tmp$
sysop@eida:~/tmp$ wget -O ~/tmp/IV_AGST.stationxml "http://webservices.ingv.it/fdsnws/station/1/q…
-
The scanner computer in the lab only has python 2.4.3 installed. I did a bit of digging on the issue of making a script work in python 2 and 3 and most sources suggest to only support python 2.6+ and …
-
Hi,
I would like to suggest a technique to drastically improve the voltage reading accuracy beyond the hardware limit of 10bit. Especially this would be helpfull for higher volatages for batteries >3…
-
http://mhz100q.sourceforge.net/doc_full.shtml
Prerequisites section says:
> Hardware needed:
> Preamplifier or attenuator (optional, if not connecting a low-level 50 ohm source).
The page …
muojp updated
7 years ago
-
Hi Tobias,
the svxserver, you kindly enclosed into contrib directory, is used by some hams here and partly outside of DL (e.g. SP).
The idea was to have the functionality to connect independent node…
-
I made few tests in order to find a way to reduce the amount of internal noise of my mcHF, feeling that the receiver seems to have an oversized gain at some stage, this conducting somehow to an improp…
-
Hi Pavel,
Just noticed a minor error in the HPSDR transceiver. The receive attenuator has two settings 0dB or -20dB and they seem to be reversed, i.e. choosing 0dB inserts 20dB of attenuation whilst …