-
Hi Cadyn,
I noted today that it looks like a [person got the Etherkit library to work with the Si5351](https://www.youtube.com/watch?v=R5qr2HKmTQY). They used GPIO20 and GPIO21, not the ones you use…
-
CEC defauits ot 0x60 when a bad I2C address is found. The Settings Editor should log this.
AJ6CU updated
10 months ago
-
I'd like to get a good overview of the installation, especially the RGB LED to indicate modes. I can't see much about it other than the Pinout showing the normal power LED is for some reason powered b…
-
Starts failing to build with linux kernel 6.6 on my system. 6.5 was working correctly.
```
make -C /lib/modules/6.6.1-arch1-1/build M=/var/lib/dkms/tbs_6904_se/6.0.11/build/media_build/v4l module…
-
Hello, first of all a huge thanks for these joby ;)
Then i have a custom board with an ADAU1701, an esp12f as master, an stm32 as usb audio device and an si5153c as master clock reference.
The stm3…
-
Why is it that in this design you only have a single RF source going into the FST3253, while in other designs including your own, you also supply an inverted input signal to pin 7?
-
cozy@cozy-Z590-UD-AC:~/ExtIO_sddc/SDDC_FX3$ make
mkdir -p obj
arm-none-eabi-gcc -Wall -c -mcpu=arm926ej-s -mthumb-interwork -o obj/cyfx_gcc_startup.o cyfx_gcc_startup.S
arm-none-eabi-gcc -g -DTX_E…
-
I was wondering if there was a way to further decrease the allowed starting frequency for sweeps. 800hz is worlds better than 50k for my purposes, but it would be nice to have the option to decrease t…
-
I have seen that CLK1 of the SI5351 is always on (7,074) is it possible to
set it to off? This could be also a problem, mybe there is some RF from the
SI5351 entering into the SI473X AMI pin8
73 …
-
Hi, I can compile a version which transmits wspr , Horus V2 and FT8 on HF (si5351) but the FT8 signal however is undecodable.
Instead of a normal FT8 transmission there appears an FT8 signal which …