-
Hi,
I need to measure the tilt angle as precise as possible (
-
I am limited to 150-180 bytes/s on the transfer speed when I write data from the STM32WB55 to a RPI with read and notify.
I have tested different timings for when the device poll and the advertising…
-
adjtime() is the semi-standard method used in NuttX, Linux, and FreeBSD to gradually adapt the system time so that it is in agreement with RTC time. It differs from clock_synchronize() or clock_resyn…
-
**Describe the bug**
When there is no secondary clock defined in dts (`clocks` property) then UART clock (`usart_ker_ck`) it is not set at all (in `RCC_CCIPR`).
In case when bootloder has different …
-
**Is your feature request related to a problem? Please describe.**
The new HAL(v1.1.14) for stm32wb is released and it should support BLE extended advertising in Zephyr while using firmware stm32wb…
-
I'm try to use BLE controller stack in STM32WB55 to comunicate with Zephyr BLE host stack with no success.
In network procesor M0+ run ST propriatery controller stack "stm32wb5x_BLE_Stack_full_fw.bin…
-
Hi @CMOSTM
The `STM32L152RETx.xml` defined the GPIO configFile version as: `STM32L162xE_gpio_v1_0`
https://github.com/STMicroelectronics/STM32_open_pin_data/blob/d1b80258bc63add9baad70be0ef74f3c4…
-
**Describe the bug**
Running Bluetooth application with SMP in peripheral mode.
When connected to from remote device errors codes are received indicating that connection procedure failed.
However t…
-
**Describe the bug**
The stm32wb_ble sample on nucleo_wb55rg board hangs on when it is used in combination with stm32wb5x_BLE_Stack_full_fw.bin (version 0.13.2) as a BLE firmware.
After updating BLE…
-
**Describe the bug**
For the same reason legacy adv reports are discaradble, extended adv reports with just legacy data should also be
**To Reproduce**
I haven't proved that this is a issue by te…