-
Cheers @sbidy ,
Could you clarify the installation instructions steps. As a new HA user I had trouble accessing and finding 'custom_components' directory. "WiZ Light" integration will also not appe…
-
### The problem
When a light that (only) supports `COLOR_MODE_RGBWW` is set to a color temperature (e.g. using the `color_temp` option of `light.turn_on`), this will use the RGB channels instead of t…
-
### The problem
After updating to 2022.2.0, I can't seem to control the white channel of an ESPHome light via HomeKit.
My use case is an RGBW LED strip connected via ESPHome, and as the strip has …
-
I get erratic error messages and recessed lights not responding correctly either turning on or off. I don't seem to run into this issue with the Wiz light bulbs. Thoughts on if there is a difference b…
-
The Integration works very well so far.
Except for one thing which is setting the white temperature.
Whenever i drag on the slider, it does not move even though it shows a (very high) number that ch…
-
Hi,
After updating to 0.4.3, some colors seem to be limited to pastel hues, i.e., much less saturated than with the previous release. Rolling back to 0.4.2 fixes the problem. Note that some colors …
-
I was wondering if it might be possible to Enable and Disable a WiZ Motion Sensor via wizcon? I see that it mostly uses pywizlight but have not found that setting there.
-
I'm wondering if a recent Python or other library update has caused this? The following basic wizcon command was working fine just a day or two ago. FYI: my bulb is ping'able...
pi@jpimain:~ $ wizc…
-
Hello,
I was wondering if there was a way to manually set color temperature (CT) values for Philips WIz bulbs using HomeKit. Another developer on the Hubitat side of things has created a device cod…
-
I have twelve WiZ lights in my configuration. Setup was difficult because associating the IP address with each bulb is complicated. After all lights were configured and working correctly with Home A…