-
Hi bro !!! Today I've a `git pull && python vdu_controls.py --install` and it breaks my VDU
I am using ddcutil 2.0
![image](https://github.com/digitaltrails/vdu_controls/assets/14153649/8a875409-3…
-
The naming of entities becomes very confusing when there is more than 1 EP1 device in HA.
Recommend using $name or ${name} in front of all switches and sensors. example below.
substitutions:
…
-
Hi, I'm planning to build this and currently BH1745( Colour and luminance sensor) has been unavailable for a long time. Since the calculation part just shows that luminance is used. Can BH1750 which i…
-
Hi,
Using ESP32 nodeMCU-32 board.
I cannot see in any of the examples where 'float luxFactor' is used?
It is specified in the wiki to allow for sensor calibration, however I am obviously using it…
-
### The problem
When I used the wakeup pin on the esp32-c3, the compilation times were wrong, Although the esp32-c3 does not have a touchpin, it can be awakened by raising the level on the gpio
### …
-
Hi! i have 2 usb cameras connected (I know you disencourage the use of this type of cameras). how can i pass from one to the other?
indi webcam ccd connect directly to /dev/video0, i want to use vide…
-
Hi Dear Wolle!
When you put the radio into sleep mode using the button on the remote control and then exiting it by pressing the same button, the radio reboots with this image
![IMG_20240426_235321]…
-
I've been getting this error when building on VScode in Windows.
If I build the exact same code in Linux (using command line) it just works out fine.
It happens with PIO 5.0.1 and the latest 5.0.2 d…
TD-er updated
2 years ago
-
I had gpio working with "AllSky"; decided to check out "Indi-Allsky" and am getting the following error (I have a dew heater and fan devices installed and setup; I re-ran setup script to make sure gpi…
-
`/*
Advanced BH1750 library usage example
This example has some comments about advanced usage features.
Connection:
VCC -> 3V3 or 5V
GND -> GND
SCL -> SCL (A5 on Arduin…