-
# Description
Perform all steps necessary to pass the test associated with flow 4.8.4 in the certification testbed.
# Exit criteria
- Turris Omnia OpenWrt with firmware master branch
- Certi…
-
The prplMesh agent on Turris Omnia with OpenWrt needs to pass the certification test case 4.5.1 as defined by the Wi-Fi CERTIFIED EasyMesh (tm) Test Plan.
- [x] #363 AP Radio Basic Capabilities and…
-
The prplMesh agent on Turris Omnia with OpenWrt needs to pass the certification test case 4.3.2 as defined by the Wi-Fi CERTIFIED EasyMesh (tm) Test Plan.
- [x] #421 Client Association Event
- [x]…
-
The prplMesh agent on Turris Omnia with OpenWrt needs to pass the certification test case 4.5.3 as defined by the Wi-Fi CERTIFIED EasyMesh (tm) Test Plan.
- [x] #370 Pass flow 4.5.3 test in testbed…
-
## Description
A CMDU's source address may not be the AL-MAC address of the transmitting device, but responses must be sent to the AL-MAC. Therefore, a mapping of source addresses to AL-MAC address…
-
## Description
For certification, it is sufficient to only support part of topology discovery (cfr. #120, #186). For a fully operational controller, however, it is needed to fully support topology …
-
The mediatek device used for the certification tests in CI sometimes stops beaconning completely.
When it happens, the error message is usually pretty specific. For example:
```
No Beacon frame f…
-
Here is an example of a failing test: https://gitlab.com/prpl-foundation/prplMesh/-/jobs/463976154
There is an issue with the operating classes, which might be related to changes we recently did on…
-
## Description
When debugging a failing certification test we sometimes miss additional information on the device like the bridge settings, hostapd status, and so on.
Could also help debugging h…
-
Currently, the son slave is updating VAP credentials regardless of the operating mode.
This means that prplMesh is *always* tearing down all radios, which is fine in EasyMesh mode BUT not in a produc…