-
- [x] Update ports to ISO5356
- [ ] When mated with Sensirion M-SEN-SFM3300, gap measured 11.4mm compared to 1.15mm in model.
- [x] Update nut pockets to prevent nut from spinning
- [x] Emboss pa…
-
All printed parts need to have part number and current version/milestone text embossed or extruded located on the body when released. This will need to be done manually (unless possible to add python …
-
Tinker tools with the Direct Modifier duplicate Glowstone blocks in the following fashion:
- With Silktouch (used Sponge Embossment): Glowstone Block + 4 Glowstone Dust
- Without Silktouch: 8 Glowst…
-
What is the status of support in card.io for printed (non-embossed) cards that has the info laid out in a vertically oriented fashion? They've been around for a while and seem to be becoming increasin…
-
Use color palette centered around the orange
Maybe stick to white as a background, but artfully use the other colors somewhere
set table width to equal what map would be
Front page: Set map to be …
-
- [x] Check o-ring groove
- [x] OD of bore as it mated with P-TET-000023 was too tight, need to reduce to avoid interference
- [x] Reduce amount of material used in part, cost saving
- [x] Emboss …
-
I have a question regarding SDK for iOS. Does it scan Credit cards only with embossed numbers? Because I was trying to scan debit card with printed numbers, it is not taking.
Kindly give response for…
-
```
let nodeFX = node.get('objectEffects').data;
// data is not defined is the node has no fx options.
```
This property contains all the informations from the FX (also called blending options) f…
-
re #2633
> If someone has a good use case for linenumber, currentfilename and/or mainfilename, please write and example and open an issue - I am happy to revisit this topic when I see a good use c…
-
- [x] Method to constrain nuts did not prevent them from spinning during assembly
- [ ] 22M port is not ISO-5356 compliant
- [x] Add embossed part number to model
- [x] DFA - Remove extra one way v…