-
Hi,
I'm using your RPi image for low cost gateway. It boots fine and I would like to test communication with a end device.
I bought some [ST LoRa demo boards](http://www.st.com/en/evaluation-tool…
-
### Current Situation
With the original rtl_433 version and an SDR stick I can retrieve the BRESSER 7-in-1 weather station with the following command: rtl_433 -f 868.2M -s 1000k -X 'n=Bresser-7in1,m=…
-
### Link
https://www.alibaba.com/product-detail/Smart-Knob-Dimmer-Switch-WiFi-Tuya_1600574868597.html
### Database entry
{"id":2,"type":"Router","ieeeAddr":"0xa4c138099d6e6eda","nwkAddr":21784,"man…
-
Add a button to the left of the A/B/C IF filter buttons in SSB or SSB DATA modes to easily set the hi+low / shift+width modes.
SSB mode: `EX00611 001` sets shift+width, `EX00611 000` sets hi+low cu…
tonyc updated
4 months ago
-
hello,
well by any chance is there a way to support the 868MHz ESP32 LoRa boards for Bresser 6 in 1 sensors ?
the rtl_433 does support the 868MHz ...
many thx
-
# Model Information
**Model Name**
Listeria monocytogenes in frozen fruit and vegetables including herbs, blanched during processing_V2
**References**
[To the model!](https://knime.bfr.berlin/knim…
-
I've gone on a bit of a mission to see if it is possible to use the QRP-Labs QDX with Winlink. As the QDX only supports single carrier modes, I'd like to be able to only enable FSK modes with ardopc.
…
-
This may be related to #294 . I am trying to use gpredict for greencube. To define both the uplink and downlink frequencies, I added the following section to `~/.config/Gpredict/trsp/53106.trsp`:
```…
-
Hi,
I have started writing an ANSIBLE script to take care of
1. FSKlab Development Repository as zip
2. FSKlab main Repository as zip
3. landingpage backend as zip
4. landingpage frontend as …
-
With the lasted build and trying to decode a BPSK observation I am running in the following error:
`gr_satellites satellite: error: unrecognized arguments: --f_offset 12e3`
I am trying this with…