-
Firstly thanks so much for this plugin, it's great!
I can see that the motion sensors are presented to Homekit through Homebridge along with the door contacts, but whilst the door contacts do reflect…
-
Confused, why does it say "Connected to Alarm!" but then tells me I can't log in? Am I doing something wrong here? Also, under password, do I put the password to the IP device (IP150) or one of my use…
-
Hi. I tried to arm the system with a contact sensor open and zone bypass switch off. I wanted to see the failure and hoped it would come back with a message like unable to arm due to a zone open. But …
-
### What happened?
I was playing around with alarms and the contact sensor that I had installed at home. I found out that when I select away it is actually registering home in the eufy application an…
-
Hello, I was wondering if it's possible to make the on/off state for the system an armed instant/disarmed state. I'm trying to use this with SIRI, and while I can get it to recognize the system, it ca…
-
Is there anyway to integrate the Ezviz Alarm Hub, Open Close, and Motion Sensors into the plugin as well? If not - do you know of any other plugin that can do this for me?
-
I don't know if its an issue on my side, I have an iSmartAlarm system, which only communicates using IFTTT, webhooks and stuff like that.
I've realised that when I send a command (i.e. ARM) to the …
-
Hello, I'm getting these messages in the homebridge command window
[12/2/2018, 6:03:59 PM] [Alarm System] Getting target state
[12/2/2018, 6:03:59 PM] [Alarm System] Not a valid HomeKit State: und…
-
- Homebridge version: 1.3.1
- Plugin version: 2021.2.2
- OS, including release name/version: Synology NAS & Docker
- [ ] Homebridge-Onkyo installed via OS/distribution mechanisms
- [ ] You install…
-
Getting the following message in my homebridge logs everytime homebridge restarts.
[19/05/2024, 10:51:18] [homebridge-orbit-irrigation] This plugin generated a warning from the characteristic 'Mode…