-
When optional 5V regulator is used and 12V power supply is connected, 7805 temperature reaches >90*C.
Proposed solution: use 5V DC/DC converter module, like this one:
https://www.ebay.com/itm/5W-9V-…
-
1 adet L298N motor sürücü, 1 adet LM2596 güç kaynağı 5v, tank şasi (2 adet dc motor üzerinde mevcut), raspberry pi3 (wifi ve bluetooth üzerinde), 1 adet arducam, 12v lipo batarya, jumper kablolar, 2 a…
-
Research replacement motor controller and 5V regulator.
Document on wiki
-
I used DC-DC LM2596 for power supply of motor MX-28T, perhaps one of the wires is disconnected and my computer is switched off. Thereafter USB2DYNAMIXEL ceased to detect the presence of motors via pro…
-
Hello again!
I were running 5.6.9 when this happened. I'm suspecting it's Mycodo for two reasons. It's almost the only thing I'm using it for, and the daemon.log is nearly full of Mycodo. Nothing e…
-
Sorry to post this as an issue, but I'm having trouble to understand how to align for double sided pcbs. Is there a reference anywhere for this? So far I've only used pcb2gcode for drilling and done t…
-
https://scontent-sjc2-1.xx.fbcdn.net/v/t35.0-12/18261096_1879228495436012_1187553086_o.jpg?oh=278e83e7515d25f8c096b4fc1dbe6f51&oe=59083A86
https://scontent-sjc2-1.xx.fbcdn.net/v/t35.0-12/18235799_187…
-
When running @24v with JP102 -VSEL pins 1-2 selected I found that the 7812 is getting very hot. I could actually smell it even with a fan running. I believe this would be a fairly typical problem when…
-
does you send the signal to the ESC direct or you use some interface between RPI and ESC in V1 and this video https://www.youtube.com/watch?v=cc01GgzKo0c is V1 or V2 and if you use the servo plaster d…
-
hello,
i like your entire project from kickstarter till now , i look at the schematic
i …