-
Looking for ways to avoid unnecessary delta kinematic calculations.
I know that Z_AXIS raw vs logical is used for home_offset, but are the X and Y workspace shifts EVER used for delta? If not I ca…
-
So, I noticed that someone has started adding Klipper to the [reprap wiki G-code page](https://reprap.org/wiki/G-code), but obviously from their point of view Klipper has a pretty minuscule feature se…
-
I love Marlin, it is a big conrtribution to Reprap. I am not much involved in the development of it but when I find a solution for something I need, I propose the addition of it to the Marlin. I do no…
-
Hello,
Excerpt: LIN_ADVANCE on delta slows down print, breaks print and gives a lot of "humming" an all steppers while printing.
Long:
I did a switch from repetier firmware to marlin 1.1.1 be…
-
Hello, I discovered that my Simplify3D start script doesn't fully work in Klipper. My start script is customized to prime and purge the nozzle off the edge of the build plate and then sets the nozzle …
-
Hi, i just wantet to tune my acceleration and tried to type in my JD of `0.013` which is marlins default value
but your form only allows values with two decimal places so i can't put in my actual nu…
-
Hi, I did this post on the reprap forum, but after a couple of posts nobody seems to find an answer for this strange behaviour:
http://forums.reprap.org/read.php?13,358655,373531#msg-373531
The thin…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Current bugfix 2.0.x 754b3191
directly related to https://github.com/MarlinFirmware/…
-
**Hardware Setup**
Stock FLSUN Q5 Board, MKS Robin Nano based I believe.
**Describe the problem**
With the FLSUN Q5 board, the bootloader only recognizes a specific filename, that is not firmware…
-
I have Rumba (with 1.1.0-RC7 of Marlin) board and ATX power supply. PS_ON rumba's pins connected to PS_ON power supply's pins. Also i have OctoPrint server (CubieBoard 2) powered from same ATX (from r…