-
The longest part of the NAND dump appears to be the transfer to the SD Card, Since all of the dump files are ~3.2 Gb is it possible to load it into the Switch's ram (4GB total) and then run compressio…
-
Shorting two pins to enter EDL on E5788, and when I run a command `edl --loader ENPRG9x55.mbn printgpt` I get `AttributeError: 'NoneType' object has no attribute 'NAND_DEV0_CFG0'`:
```
$ ls E5788
…
-
Hello! Thank you for publishing Dhara.
I have been playing with it and wanted to share some performance numbers. I am using a NAND Flash chip on an embedded system. When I use my raw nand driver, I…
-
To facilitate research, the controller needs to be able to be interrupted so that we can drive signals onto the NAND signals at specific times. This should be a branch of its own and not be merged int…
-
Currently the controller is designed to support the MT29F256G08CBCBB family.
The original controller was compatible with the ONFI protocol but once hooked up to the Micron memory model was getting …
-
I have cubietruck (cubieboard 3).
I want prebuilt cubian X nand image.
I cannot use cubian nandinstall since the sdcard slot of the cubietruck is damaged.
Is it possible to build the cubian X nand i…
-
```
What steps will reproduce the problem?
1.Download OMAP35X.tar.gz in TI_Android_DevKit 02_02_00 and prepare SD Card
2.Set SW4 as ON(1)-OFF-OFF-ON-ON-OFF-OFF-OFF
3.Power ON
What is the expected outp…
-
Hy guys,
This turorial ( https://github.com/cubieplayer/Cubian/wiki/Why-the-total-memory-is-827MB-instead-of-1GB ) don't work in cubian R3, when installed in NAND. Work's fine in SD CARD.
Any tips ?…
-
```
What steps will reproduce the problem?
1.Download OMAP35X.tar.gz in TI_Android_DevKit 02_02_00 and prepare SD Card
2.Set SW4 as ON(1)-OFF-OFF-ON-ON-OFF-OFF-OFF
3.Power ON
What is the expected outp…
-
```
What steps will reproduce the problem?
1.Download OMAP35X.tar.gz in TI_Android_DevKit 02_02_00 and prepare SD Card
2.Set SW4 as ON(1)-OFF-OFF-ON-ON-OFF-OFF-OFF
3.Power ON
What is the expected outp…