-
Hi, I noticed after the updated to 0.2.7 that the ONVIF server is not auto-started when the cam boots. I searched in the issues and I found some old code to manually launch the server and with this co…
-
Please add up setting PTZ sensitivity.
Using on-screen controls results in too high sensitivity, making it impossible to control camera movements accurately (it moves too far, zooms too much using on…
-
## Version of the custom_component
v5.2.0
## Configuration
```yaml
mqtt:
# Required: host name
host: XXX
# Optional: port (default: shown below)
port: 1883
# Optional: top…
-
### The problem
The G5 Bullet camera, which has smart detection for persons enabled, is integrated into Home Assistant via the `unifiprotect` integration. This setup includes a binary sensor `Person …
-
## Feature Request: MQTT-Based PTZ Control for Non-ONVIF Cameras in Frigate
### Goal
Enable PTZ control for non-ONVIF cameras like the Reolink E1 via MQTT in Frigate, improving home security by al…
-
So I've been working on getting Viseron to work (thanks for all the hard work by the way). I've got what I THINK is suppose to be working, however I can't get anything to trigger record. Initially wh…
-
1. **[Specification Text]** Each camera shall use an individual ascending interval strategy to avoid that all cameras connect at the same time.
- How is this possible unless camera A knows the pa…
-
What could it be ? Tnx !
![image](https://user-images.githubusercontent.com/879825/131043283-91bd9444-eed6-450a-8af9-5795718b89d7.png)
-
Using h51ga 0.3.1 on this camera, S/N: SFUSY45RI6YAH5230518
First installation works, but after a reboot, without changing any parameter, it enters on a boot loop.
is this the correct FS for thi…
-
Installed Version 0.2.6.1 on Wysecam V2. New firmware booted and can access the web interface but cannot access RTSP on port 8554 or 554.
When I enable RTSP H264 Server under Camera Controls, it i…