-
Hi,
Does anyone have the .Bin file of the edgetx firmware for a Radioking tx18s? (the same as the jumper T18) My radio has the access mode (hardware modification). I have already tried the different …
-
I have a 2018 r9m, accst vesrsion, and a r9mm-ota access receiver. I have successfully flashed both and just went through again to make sure that everything is the same for userdefines when flashed. I…
-
no register mode for the r9m module on my ethos x12s transmitter. works fine on my open-tx x10s express.
-
### Your Name
Aaron Ponce
### Your Email
aaron.ponce@agile6.com
### Your Role and Team
Front End Engineer VSA Debt
### Product Manager (PM) name and email
denise.coveyduc@gcio.com
### Product …
-
用这个issue,保存btn-8的视频数据
-
Currently there is only preset for ELRS 50Hz/150Hz/250Hz/500Hzcontrol link. However, ELRS 915MHz runs at 200Hz, which isn't covered by any available presets.
Here I post my flyable settings for ELR…
-
As we are not able yet to use the OpenTX Companion, we have no option to enable and disable firmware features.
So as the title says, the following features are missing:
- [x] FrSky R9 FLEX Firmw…
-
### Is there an existing issue for this feature request?
- [X] I have searched the existing issues
### Is your feature request related to a problem?
I installed EdgeTX on both X10S-Express and X12S…
-
## Current Behavior
While flying on two occasions, the link was lost at close range, and even once the aircraft crashed/landed and the TX was within 10ft, the link was not re-established. Power cyc…
-
## Current Behavior
Very often I encounter problem where the quad has terrible LQ in relative proximity of the controller.
I have this problem on my two quads:
1. 5" that has R9mx that sometimes e…