-
I have not been able to connect with CC2652 to zigbee2mqtt.
This is my log:
Using '/app/data' as data directory
Starting Zigbee2MQTT without watchdog.
[2024-07-13 12:03:11] info: z2m: Logging to …
-
`ModbusSerialSlaveNetwork.ListenAsync()` never yields execution with an `await` operator, and will block indefinitely until the underlying serial port is closed. This can be verified by running the `…
-
Problem detail : http://www.raspberrypi.org/phpBB3/viewtopic.php?f=44&t=8010
I, like a few others, have been having various problems using USB/Serial adapters with RPi. One of them is the FTDI adapte…
-
Working with an arduino, I've found that the last few seconds of information will be output by
.read() before catching up to output the current state.
Not sure how to make sure this is the fault of…
-
I believe some way to set baud rate for the serial traits is needed.
### Relevant problem
[Dynamixel](http://www.robotis.us/dynamixel/) servos comes with two different RS-485 protocols that have s…
-
Is there a way to implement broadcast messaging in NModbus?
A broadcast message is sent to node 0 and has no response from the slave devices. As far as I can see writes to node 0 are handled the sa…
-
What is the preferred approach to add support for instruments that do not use SCPI to interface with the adapters. My thinking would be to write an interpreter to convert the non-ascii commands to SCP…
-
The 4 channel relay available on AliExpress comes with firmware on the nuvoTon chip on the PCB that expects the ESP01 module to respond to AT commands, but this app does not.
If you add some simple c…
-
I am an automatic service from ioBroker that searches adapters and makes suggestions.
I noticed that your adapter is not integrated in the ioBroker.discovery. Using the Discovery adapter, ioBroker …
-
Hi @madhephaestus!
I'm (with the help of @wborn) trying to improve the RFC2217 experience in openHAB and, while making some changes to the openHAB Z-Wave binding, I have realized that the nrjavaser…