-
Hi
I followed the same procedure as given for the Marlin Firmware upgrade and got the firmware file. But when I upgrade the board, I get "TMC Connection Error" and the motors are not working properly…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Marlin applies an incorrect Z offset after bed leveling, when using the simple "home" t…
-
The board does not function as intended when BTT TMC2209 V1.1 driver's DIAG pins are inserted. Endstops will fail to trigger in all cases.
If the pins are removed or not inserted, endstops functio…
-
What is pin number for the diag1 pin on an SKR mini E3 Dip to use sensorless homing. I cant find it on any schematics. I am using TMC2130 for X0/X1 and TMC5160 for Y on one board and Z0/Z1 E0/E1 on …
-
I was trying to use the `SKR E3 DIP` with TMC5160 drivers.
I copied the `generic-bigtreetech-skr-mini-e3.cfg` and changed the PINs according to the [sheet](https://cdn.shopify.com/s/files/1/1619/47…
-
I just upgraded my Ender 3 Pro to SKR 1.4 Turbo (firmware not installed yet) and the TFT35. When I power up the system the magic smoke did not escape, but it remains blanks and flashes....waited for …
-
I installed my SKR mini E3 into my CR-10 yesterday being careful to plug everything back in where it should be. When I turned it on I expected to have a working system, but the screen was completely b…
-
Hello, I changed the motherboard from E3 DIP to SKR 2. I have a problem with reading the temperature. Both for the nozzle and bed. I have measured the nozzle.
The software is marlin 2 bugfix.
My…
-
BTT SKR Mini E3 V2
Marlin Bugfix 2.0 from 3.1.2021
starting Printjob in Marlin-Mode
Part Cooling Fan not starting after Layer 1
Fan startes at 100% (was set to 30%) if klicking the Wheel at BTT TF…
-
[klippy.log](https://github.com/KevinOConnor/klipper/files/5415451/klippy.log)
I've setup a bltouch on an SKR Mini E3 V2.0. The accuracy check shows a s.d of ~2 microns:
```
probe accuracy re…