-
Hello,
according to the official embedded HAL traits, it is encouraged to use an `SpiDevice` where ever possible, instead of requiring the entire `SpiBus` and an extra chip select pin (CS) (see [he…
-
Given the popularity of esp32 devices, the [esp32 C3 serial protocol](https://docs.espressif.com/projects/esptool/en/latest/esp32c3/advanced-topics/serial-protocol.html) is a good candidate for initia…
-
Currently, address fifo and the payload do not have any information that SW is able to figure out which command these address and/or payload belong to.
If the host system follows the protocol corre…
-
Requested in this thread: https://forum.digilentinc.com/topic/5058-digital-analyzer-protocol-support/
SPI, UART, I2C
-
Open discussion about possibility of an esp-zigbee radio library for zigpy to use esp-zboss via serial interface, what do you think?
For zigpy projects to use ESP32-C6/ESP32-H2 based ESP32 radio mo…
-
These 2 FPGA bugs are currently accounted for in the pi software, but posting here so they are documented (and eventually resolved).
- first byte of audio FIFO buffer needs to be flushed on reset.
…
-
Hi, I just tried to connect, and the switch seemingly recognizes a new controller, but as soon as I try to send a command, connection is lost:
[14:32:53] joycontrol.device set_name::69 INFO - setti…
-
Device [https://www.aliexpress.com/item/2251832668606248.html](https://www.aliexpress.com/item/2251832668606248.html) 4MP 48V POE, sensor branded as sc5239s which should be a sc223a.
Flashed with `…
-
### Describe the bug
Hi,
i tested this 4.3.1 on two H7 boards: MAMBAH7MK4 and TMOTORH7.
when the quad is powered up, changing the gyro from first to second (or vice versa). on reboot the motors…
-
Feature request and heads-up; Silicon Labs is phasing out EFR32MG1x + older HW not included in newer Simplicity SDK versions:
EZSP protocol version incremented to EZSP v14 in Zigbee EmberZNet v8.0.…
Hedda updated
3 months ago