-
I have connected LLCC68(Ra-01sc) module to Arduino UNO, but I have got different errors from SPI
1. Initializing ... failed, code -707 - if I set BUSY pin
2. [SX1262] Scanning channel for LoRa trans…
-
你好,现在在安卓上调试sx1268这颗芯片,想问下你的代码能否移植到安卓上,因为刚接触驱动这行很多东西都没碰到过,希望大神能指点一二,谢谢!
-
When I execute radio.transmit() function after using radio.beginFSK(), I get "[SX1278] Failed to receive the packet, code -16" , however when i change the function to radio.begin() there is no error. …
-
```
int state = radio_tx.begin(RADIO_TX_FREQ, 125.0, 9, 7, SX126X_SYNC_WORD_PRIVATE, 10, 8, 1.6, false);
g_RADIO_TX.frequency = RADIO_TX_FREQ;
if (state == ERR_NONE)
{
printUART("suc…
-
Hii
Updated the Radio Lib on 29 Dec 2019.
Thanks for your support! Am getting ERROR State 707 with LORA SX1268 - With DORJI Development Board with arduino UNO only on the Receive Example
Same error…
-
Hello! Hoping to use the lessons learned from my first attempt at building this device, I used extraordinary caution when assembling my second attempt unit. No detail was too small. (I actually did…
K4KDR updated
3 years ago
-
Is there a certain button combination that puts the Evil Crow in programming mode? Every time I try to flash RFQuack, it fails.
-
NOTE: This is a question rather than an issue. I [posted it on the forum](https://forum.arduino.cc/index.php?topic=634356.0), but got no replies, so I'm re-posting here! ;)
---
I am playing with…
-
I want to use recieve with interrupt on SX1268 however I am constrained by the no. Of pins I have available. So can I just put DIO2 pin as -1 and still use the recieve interrupt feature?
-
Hello,
to start with I ordered and assembled the same Adafruit modules found on the photos on the RFQuack github site:
![494A5A58-01BD-43EA-80A2-702C1E1A7B7F_1_105_c](https://user-images.githubu…