-
Note: I am still on 1.3.10 (not sure where to clone the repo so that I can off of master).
I have the following code:
```
#include
void setup()
{
Serial.begin(19200);
SD.begin(7)…
-
My code worked as expected with 2.4.2 but after I had installed 2.5.9 the loop seems to be restared after an IRQ from the PWM in arrived and does not get finished after. The behaviour changed at least…
-
So I eventually got around to updating from 1.3.10 and a couple of things stopped working.
1. the standard I2C bus scan finds a device at every address, not just the one device that is actually pre…
-
I am working on building my own hardware and use external 24Mhz Crystal. I couldn't make it work properly. 24Mhz Internal works well, no issue there. If I change it to 24 Mhz Crystal, code doesn't run…
-
I trying to upload a blink sketch to an AVR128DB32 processor.
Using a FTDI board (Robotdyn) witch has a CH340H chip onboard.
Added the diode between Rx and Tx and have a 470R resistor in series wi…
-
Hello this is not a issue but a question. I’m trying to get attiny1614. I’m trying to put it into sleep mode and wake it up every 10 seconds. However I can’t not find any example code online that can …
-
We need the following in order to write generic code that makes use of the event system. The current Event library is essentially useless for this, as the user needs to know what the target processor …
-
I've just released picoboot-lib, which I believe is the smallest and least intrusive bootloader for tiny AVRs.
https://github.com/nerdralph/picoboot-lib
It uses the last 256 bytes of flash + 2 bytes…
-
How do I solve this?
```
//=============================================================
void RTC_init(void)
{
/* Initialize RTC: */
while (RTC.STATUS > 0)
{
; …
-
Tested code on ATtiny3217 and 804,
#include in DSTherm.h:16:10: fatal error.
Though compiles for old AVR and RISC.