-
Hi everyone, I bought two tmc5160 from bigtreetech more specifically these https://www.biqu.equipment/products/bigtreetech-tmc5160-v1-0-driver-spi-mode-silent-high-precision-stepstick-stepper-motor-dr…
ghost updated
3 years ago
-
I just purchased a BTT SKR 1.3 and BTT TMC2209v1.2 drivers.
i am installing it into a Kossel mini that i previously had an 8 bit with TMC2208 working just fine.
i'm running the firmware located in…
b3nnb updated
4 years ago
-
Hi !
This is not an issue, I'm the issue because i'm a really noob about code ...
But thank's for your cool and hard work about TMC chips.
My coding level can't go further than to use simple th…
-
Hi,
Currently developing board based on tmc2160, losed tmc5160 because it pointless without supporting encoder feedback on marlin side. So, to reduce amount of wire i decided to make uart-spi bridge,…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
In file included from Marlin\src\HAL\STM32\../../inc/MarlinConfig.h:49,
fro…
-
Hi , i am working on a project and i want to use the tmc2209 to control a stepper motor . But there is not much documentation on the internet and i don't know how to connect it to arduino or what code…
-
Hi!
i'm having issues compiling... do you have a newer version?
SKR DIP e3 with 4x2208 on a Ender 5
Thanks in advance
-
Hello world, my first post @ git :) I have read similar topic which is closed, there was no solution for problem.
I switch from ramps to skr 1.4 turbo (Marlin 2.9.0.1), got 2x tmc2099 for X,Y but i w…
-
Hello,
I was looking under the pin group and I didn't see a pin specific for "auto power off after print", I am assuming that PS_ON_PIN?
I am using an inductive z probe and I wanted to know the m…
-
### Bug Description
If you turn on the stepper motor E0 and then use the encoder, garbage appears on the screen.
### Configuration Files
Included
[Configuration_and_adv.zip](https://github.c…