-
Hi I have some questions regarding this project.
Is this a "write once run everywhere" project? That means that if I write code for the Arduino, the exact same code would work on a Raspberry Pi, fo…
-
### PROBLEM DESCRIPTION
The ultrasonic sensor A02YYUW (DFRobot SKU:SEN0311) which uses a serial UART @ 9600 baud with 4 byte output does not work with sr04 module when the Tx line of the sensor i…
-
### Summarize of the problem/feature request
If you make 2 Ultrasonic devices both will have the same reading
### Expected behavior
they shouldn't have the same reading
if added separately eac…
-
Disclaimer: My perspective on this is that of an FLL Coach. While I'll admit to a bit of tinkering with an EV3, 99% of my effort in this space is through the work of the 30+ FLL teams I have coached…
-
After upgrading from release 20220328 to 20220427 DHT22 is no longer working. The log states 'DHT protocol timeout'.
20220328 was working fine (and is again after downgrade).
-
**Hello,**
I want to contorl the HC-SR04 ultrasonic sensor with the Jetson Nano's GPIO pins. It needs a 0.01ms Trigger signal and sends an Echo signal as soon as the sonic wave arrives. Here is my …
-
#### Proposed title of article
[Networking] How to gain access to full remote desktop environment of raspberry pi using VNC and SSH
#### Proposed article introduction
The Raspberry Pi is the mos…
-
Hi,
I am trying to use the ultrasonic sensor to detect vehicles. But, I found that the distance I get is always 0.0 while nearing any kind of vehicle. My car is AWFLexus2016RXHybrid and ultrasonic s…
-
Hi,
Since the last update my ultrasonic sensors always return their max_distance and take far more time than before to initialize.
After checking the connections on the breadboards and changing …
-
Abstract
Motion capture from sparse inertial sensors has shown great potential compared to image-based approaches since occlusions do not lead to a reduced tracking quality and the recording space …