-
Hi, i'm tring to install the MVP, but when i run the script in the README (the buildScript.sh), it says that the zip file could not be found (the link is broken, tried diferent links, but none worked)…
-
I'm having a problem getting the barometer/temperature sensor to work. Two years ago I built the original version and with much fussing I got it to work with a BMP180 sensor from Spark Fun. The hard…
-
HI,
First off, I must take my hat off to you for producing such a wonderful project!
I have a question about the audio side of things. I'm just making a breadboard like your original prototype a…
-
Hi all,
I am trying to set uAAL in a Raspeberry pi 3 device. I downloaded the karaf distribution of uAAL ( https://github.com/universAAL/distro.karaf) and then I used the starting guide (https://gith…
-
Hi,
I use your code for some time with success, weighting bee hives using Raspberry Pi B+, hx711 and low-cost weight sensors. So far, so good. But now I found out, that if something goes wrong with …
-
On page 21 of the 2024-05-02 version of Getting Started with Raspberry Pi Pico, under SWD Port wiring it says to connect GND(Pin 20) to SWD GND, GPIO24(Pin 18) to SWDIO and GPIO25(Pin 25) to SWCLK for…
-
when i try to install wiringpi it always fail
[https://pastebin.com/VJ4mS4MG](https://pastebin.com/VJ4mS4MG)
and when i try to launch it
> sudo node remote.js
> module.js:557
> thr…
-
**Describe the bug**
Hi team, I have a old 3rd party 'Chinese' Xbox 360 Receiver - USB based. Hardware PID's are;
USB\VID_045E&PID_0291&REV_0107
USB\VID_045E&PID_0291
I am using a Raspberry Pi…
-
Hi!
I am trying to program an STM32WL custom board from a Raspberry Pi 4B+, and your code seems very promising to that end.
However, I cannot get your code to build/run. I have tried with node v…
-
Greetings guys,
I have confirmed that using [my launch configuration files](https://github.com/novemberalpha/openag_brain_pfc1_config) that the arduino flash fails with a missing Wire.h library. T…