-
I have S109 drivers based on TB67S109AFTG. They need vcc=5V.
May I set VLOG JP101 to 3-2, (FD_5V) with Due ?
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
When using MKS_UI (TFT_LVGL_UI) there are Y axis motion losses / offsets at random Z heights,…
phcay updated
5 months ago
-
Perhaps as a future enhancement we could parameterize the machine control G-code and basic UI into the machine configuration Originally discussed in #158.
For instance, even on my one machine, depend…
jmkao updated
8 years ago
-
I found and ordered drivers - lv8728, which work with 3.3 volts logic and can be used with more powerful motors, unlike lv8729. Do you need any changes in the firmware? What to write in the section st…
-
Hello All,
I'm not new to Arduino but am new to working with GRBL. I made myself a very simple file in Fusion 360, CAM'd the paths and made myself some G Code. I have been able to connect to my GRB…
-
Hi,
I am currently working on a sand table (similar to the sisyphus table) but I am a bit lost when it comes to setting up the machine in Grbl. While I've done some Arduinos projects and worked wit…
-
On the Fystec 2209 v3.0 the RX & TX pins are shifted compared to previous versions, so in order to use UART with SKR v1.4 board, you need to set the jumpers on SKR like the first picture, also you ne…
-
I received an email asking about TMC2209 drivers in UART mode. I thought it best to move the conversation to a more public space so that the collective wisdom of the open source community can be harne…
-
Hey I'm writing this be cause the lack of clear instructions on the BTT github site.
My set up:
BTT SKRv1.3
Stepper 17HS4023
S42B_V2.0 board
This is what I've done so far:
I installed the hardwa…
-
I've spent hours working with FLSUN to fix the firmware for my custom QQ-S Pro with an MKS Robin Nano V3.1 and a TS35 V2.0.
I have the Homing fixed except, if I offset any axis by a small amount ma…