-
``add "addClockEvent..." to autoexec.bat has no effect.
Maybe I just don't see how to do it properly. All the examples I've tried don't work.
**Firmware:**
- Version 1.17.571
- Device: unkno…
-
The mpsse implementation seems to be buggy. I cannot get this adapter to reliably work with OpenOCD. At times OpenOCD just hangs with the message "Haven't made progress in mpsse_flush()..."
This se…
-
Having an open source WiFi MAC on such an affordable device would be extremely useful for experimenters and researchers.
If you are worried about people disregarding the WiFi standard then that is …
-
**Describe the bug**
After entering the "Config module" page, the device no longer responds to the page or ping. The router says that the device is still connected to Wi-Fi, basic operation like turn…
-
**Describe the bug**
I have an Elivco plug with power meter.
I have installed the OpenBK7231T/OpenBeken release 1.17.136,
The plug has a small board with a BL602 and a BL0937 in a bigger board to g…
-
I have changed 0.0.0.0 to 192.168.200.239 but it's still using the old dhcp address.
The device have been swithed off but still the same problem.
Flags: 1120
**Firmware:**
- Version 1.17.494
- …
-
Is there a way to set schedules for different outlets? Id like to be able to turn them on and off at specific times and days.
Thank you!
-
Please do either of these:
- release documentation of the interface between the NONOS_SDK code and LWIP (I am positively sure it's more than the standard LWIP interface as apparently some internal wi…
-
### The problem
There are some scenarios where the light status is not being reflected in Home Assistant (but it is being reflected on Surplife app).
The scenarios, as far as I tested are:
- Bulb i…
-
All the time Wi-Fi signal strength is shown like -1 dBm (excellent). This cannot be, because the Wi-Fi module is located at a distance from the router (5-10 meters). This signal strength is displayed …