-
Hello,
After compiling the ESPhome firmware I'm getting this erros:
Showing logs:
```
[18:55:53][I][logger:214]: Log initialized
[18:55:53][C][ota:461]: There have been 2 suspected unsucce…
-
I really appreciate you for your work!
I'm testing it on bms 8S, 24v 50A, and everything works fine, but only in one case - in case of discharge.
BMS stops responding and send any data by charging,…
-
Hello,
I'm facing core crash during connection to JBD BLE device. (dump from serial line below). Anything I'm doing wrong or there is a bug in code? Thanks for advise
Connected
IP address: 192.…
-
Hi, I tried to connect the bms through bluetooth with an esp32 mcu node but the board restarts at some point with error:
`CORRUPT HEAP: multi_heap.c: 187 detected in 0x3fff4a14`
What could be the p…
-
The following formula can be used to convert voltage into % remaining on an idle XR. It works with a CBXR, and so would work with a JWXR. I don't know how it would work with VNR.
99.…
biell updated
2 years ago
-
I've made q schematic of how I understand this system to work currently and wondered whether this could be extended with the following features:
1) Current sensor to measure actual current draw and…
-
Hi, do you know if we can connect directly to the GPS/485 port our rx/tx pins of an esp8266/arduino/esp32?
I mean. What is the protocol that have that port? I suppose that it is TTL232 or RS232, as…
-
Hi friend, i need help a little bit, Twizy driving fine but my charger sometimes randomly shutdown ... solution is to just unplug and plug again, but this force to babysit your car, is there any possi…
-
### Todo
- [x] Draw up a plan / specification
- [x] Add nodejs & node-red into Venus OS (done see below; not in master yet)
- [x] Add node-red on/off switch to gui; which starts and stops the nod…
-
I have a jkbms with hardware 8.x and soft 8.0.2H, version 3.7.0. I have installed the esphome and I have put the code that you have put minus the mqtt instructions that give me an error. I have conn…