-
- Capture the temperature using DHT22.
- Capture the humidity using DHT22.
- Water temperature sensor (DS18B20).
- PH sensor (Pro SKU SEN0169).
- 2 Fans.
- Verin.
- Relay a 4.
-
I will have multiple DS18B20s on different data pins and will need to access them based on that rather than in series on a single One Wire circuit. I've looked at both the CPP and Header files and can…
-
Update Hardware wiring diagram for CBP v2.1
Example for 3 x DS18B20
Example for 3x SSR
Example for Piezo Buzzer
-
The current RMT wrapper targets the ESP-IDF library v4 interface, which does not support a TX and RX RMT driver on the same pin.
However, the v5 library does support TX and RX mode on the same pin…
-
I want to emulate a DS18B20 sensor from an ATTiny85. I have followed your instructions the best I can but fail to get it to work. Using an Uno, I can try to read the OW temperatures. The device num…
-
This is not an issue, it is only a doubt or maybe, if reasonable, an idea to improve and think about.
**Is it possible to install two DHT1x/DHT2x ?**
**Question reason:** Using two DHT, instead …
-
And use simulator by defaults, then I2C bus can be scanned to select the right controller (per address)
Relate-to: https://github.com/rzr/generic-sensors-lite/issues/5
Feedback welcome, here or …
-
I tried to run a combination of your DS2450 and DS18B20 examples on an Arduino Uno (actually it's a [clone from AZ-Delivery](https://cdn.shopify.com/s/files/1/1509/1638/files/Mikrocontroller_Board_ATM…
-
Using external DS18B20 temperature sensors for inlet and outlet, and using the pump flow rate reported by the heatpump, I think it would be possible to calculate a more realistic value of heat product…
-
Hi,
I found that BPL v2.5 (BrewPiLess.v2.5.sonoff.bin, BrewPiLess.v2.5.1.sonoff.bin) cannot detect the original temperature sensor connected to Sonoff TH10. It only shows External Sensor (but no va…