-
A module to interface to an LCD display, for example:
[Ender LCD Display](https://www.ebay.com/i/254599064474)
It needs 3 input pins for the rotary encoder and its associated pushbutton, 2 outpu…
-
**What about adding a 'soft reset' command to GC?**
Working with the firmware non-Arduino boards, I've run into an issue - Arduino Mega boards do a hard reset when the serial connection is establi…
-
This is just a request, not a bug but I don't see the option to tag it as a request or question. Sorry.
For my actual project, it would be great to have the TRIGGERED_MOVEMENT option, same as teath…
-
Hi guys,
I can't find any data about wiring, especially for motor pins.
-
#### If this is a feature request describe it here
___REPLACE_THIS__FEATURE_REQUEST_DESCRIPTION_GOES_HERE
#### Version of Octolapse
Octolapse Version: 0.4.1
#### Version of Octo…
-
Hey, nice job converting grbl for mega2560
Is there a posibility to configure grbl to use two stepper drivers for one axis simultaneously (e.g. use E1 of a RAMPS board for Y), so two steppers of a po…
-
I think I've gotten everything set up correctly, and the node app is seeing the arduino serial output, I'm getting all of the > > > and the hello world setup.
However, if I try to send gcode it doesn…
-
Impossible to do moving the servo with many different firmware. Anybody can help. Maybe a bad configuration because I have plus the 3 pin in the corner (servo pin). Thks
-
Everything is installed and working great, WebUI, wifi, bluetooth, milling and laser engraving programs, etc.
The problem is that the GRBL Controller application does not see the connected usb devi…
-