-
I recently installed a new MKS SGEN LPC1769 board in my 3d printer. I just installed a completely new source environment using an archive that was downloaded April 12 of Release v2.0.5.3. I edited t…
-
应用长时间运行（12小时以上），出现触摸失效，linux底层驱动还是ok的，cat /dev/input/event1有数据出来，i2cdetect也是没有问题，awtk不打印tslib_dispatch_one_event事件， 独立的测试程序读取出来TP坐标也是跟正常的时候是一样的
谢谢！
-
Hi,
I'm trying to use hardware serial port on STM32 in half-duplex mode. This uses a single pin on the chip for both TX and RX. (see PR #643 on stm32duino/Arduino_Core_STM32).
I'm encountering t…
-
Board was working fine for about 2 months. After being turned off for about a week and turned back on the temperature for Hotend 0 is showing stuck at 184 degrees. Even after removing everything from …
-
My SKR 1.3 isn't updating itself from SD card anymore. I put firmware.bin onto the sd card on the SKR 1.3 and restart it. Either by using the reset button or the power cycling it. Then I insert the sd…
-
While playing G-code files from the SD card, the DRO is flaky and Smoothie is not really responsive to G-codes sent like M112 (Halt). It would be nice if the DRO worked smoothly during prints, but it…
-
### FileNotFoundError:
When I try to compile I get the following error?
`> Executing task: C:\Users\r_vei\.platformio\penv\Scripts\platformio.exe run --environment STM32F103RC_btt_512K <…
-
I've been trying for 2 days to recompile other folks firmware and also tried editing the stock marlin 2 software to no avail. I am using VSC and Platformio and I have no experience with this kind of s…
-
I've had some problems getting binary packets to work right. Does anyone have an example of how to correctly calculate the checksum for the binary packet, I'm probably messing up something very simpl…
-
> Naturally I tried to dig deeper and actually found evidence that the mainboard is manufactured by some chinese company (SUMTEC Hardware).
This part of the readme got me curious to checkout the bo…