-
My TS100 iron had previously installed Ralim (unsure of version). It had been functioning like this for ~6 months. I started using it again yesterday, and did ~5min of soldering.
I went to use agai…
-
You will find photos of my mess.
I decided to use my TS100 with a power supply I had around (thought it was a 12Volt, my fault) and it resulted to be a 48 volt power brick for a POE switch...
Th…
-
* **I'm submitting a ...**
- [x] Bug report
- [ ] Feature request
- [ ] Translation
* **What is the current behavior?**
Soldering Iron does not heat above 410-420 degrees though 450 is th…
bodja updated
4 years ago
-
Hello,
I have a DS203 currently with wildcat 6.5 hw 2.81 sys 1.64
I went in DSU mode and copied the ds203.hex file, all went fine.
Disconnected, restarted and asked for shell.elf, I copied the elf…
-
* **I'm submitting a ...**
- [X] Bug report
- [ ] Feature request
- [ ] Translation
* **Do you want to request a *feature* or report a *bug*?**
Bug
* **What is the current behavior…
-
I've seen a couple of other people mention "temperature shows as zero", but my symptoms are slightly different, and they were using a different firmware version, so here goes:
Note: the following w…
-
Please help with this issue it has crippled my brand new iron
* **I'm submitting a ...**
- [* ] Bug report
* **Do you want to request a *feature* or report a *bug*?**
Report a Bug
* …
-
* **I'm submitting a ...**
- [x] Bug report
* **What is the current behavior?**
I reflashed the iron and went to see if #551 was fixed. I set the temperature to 450 °C (and in case it's relev…
-
* **I'm submitting a ...**
- [x] Bug report
- [ ] Feature request
- [ ] Translation
* **Do you want to request a *feature* or report a *bug*?**
I'm reporting a bug
* **What is the …
-
I am submiting bug report.
Whenever I chose in menu Power source 18W or 24W it takes whole 30W or more in peak what cause my powerbank to cut off as it is overloaded.
Is the option 18W or 24W limi…