-
I'm running into a challenge where the SWG changes from 0% to 75% and back.
I have the system set to 75%. The system sets to 0% for about 10 seconds, then goes to 75% (which it should be) for a sh…
-
Just recently off of issue #57. I'm not sure this could be related, but since putting on that update I've had the aqualinkd service quit on me twice, right when a new command is sent to it. In each …
-
No issue with software, but for a newb, how do i get the software to connect to the pool pump? I have a pentair intelliflow variable speed pump, do i connect the rs485 to a raspberry pi or something e…
-
# 🐛 bug report
Hopefully this is just a setup issue, but I don't know where to start. I looked at a lot of other issues but didn't see anything relevant.
In short, with Dev environment:
* Work…
-
and another controller (intellitouch/intellicom) is present.
Does this mean the software cant run when this runs?
-
### Expected behavior and actual behavior
No errors thrown
### What is actually happening (screenshots are helpful)
### Steps to reproduce the problem
unzip 5.1.1 release
npm install
npm aud…
-
I'm noticing that no matter what the salt level read is from aqualinkd that HomeKit reports a max value of 2700. For example, the status command from aqualinkd reports my salt level at 3800 (a little…
-
I have finished Alpha development on a UI to access the poolController from the SmartThings platform. This UI allows the user to see all the relevant details of the Pool in the ST platform and also ex…
-
Hi,
I have a Pentair variable speed pump that I bought last year as well as a booster pump for my pool sweeper. Also have the ScreenLogic garbage that they sell (shameful). Can you provide some detail…
-
Built this on both a Pi and an odroid get the same error below on execution. I have a JTEK rs485 attached but not connected to the intelliflo pump yet.
Error: ENOENT: no such file or directory, ope…