-
Currently only installable via ZIP folder. Robopaint deserves more class!
-
Pretty please, could you create a way to control three servos (XYZ) with CNCSERVER? It would be great to have a pause for pen swapping too.
Thank you!
-
oskay updated
10 years ago
-
Pressing the raise/lower, Home, or unlock buttons while printing is _bad_.
I have verified this by trying it.
oskay updated
10 years ago
-
[Title was: 'motion is jerky'] especially on sine fill
oskay updated
11 years ago
-
oskay updated
11 years ago
-
- Will need way to set this height (e.g., a slider in the preferences)
- Will go lower than painting height, so as to mash the bristles into the bottom of the water dish.
oskay updated
10 years ago
-
Menubar label for RoboPaint currently reads node-webkit. This may be confusing.
oskay updated
11 years ago
-
When doing test prints with highly intricate line drawings using penmode 3, drawing from SVG clipart using intricate settings, fill (or maybe stroke) occasionally draws huge lines very far out near th…
-
Any idea how to reset it so that the program can be opened again?
oskay updated
11 years ago