-
I have a few identical XYGStudy ft232rl adapters, specifically purchased for the available cbus pins to use in gpio mode. I was able to use ftconf to set the cbus pins to gpio and write the eeprom. Ev…
-
I've noticed that none of my usb-uart adapters but the MAX232 are working. The DC voltage between power and gnd is 5.04V, between signal-gnd 4.2V. Watching it on the scope I notice that the voltage di…
-
```
hi there,
Nowadays, thanks to wonderful usb-serial adapters, it is possible to run at
virtually any baud-rate. But QESP is still restricted to a predefined list.
Is there any consensus to updat…
-
USB-to-Serial adapters are often used to connect legacy serial devices to modern systems. This includes scenarios such as:
* Connecting network equipment like routers and switches for configuration a…
-
Hello,
As per title, I've been struggling to use 5 x Hauppauge WinTV-QuadHD-DVB in a single system without any success.
It seems that the driver will correctly identify 4 of the cards, but the f…
-
Hello,
In my case: Unipi G100 + M-Bus to RS485 converter + 9 x Qundis heat meters,
libmbus cannot find or read any device. Increasing time from default 300ms to min. 1100ms (baud: 2400) solves this …
-
Hi, I'm having a strange issue in which the simple example works only the first time I execute the code ,but once I try to execute again , I get the error which seems to be common here , the only way…
-
```
hi there,
Nowadays, thanks to wonderful usb-serial adapters, it is possible to run at
virtually any baud-rate. But QESP is still restricted to a predefined list.
Is there any consensus to updat…
-
Was wondering if LG model 55LN5100 could be added/is compatible?
Manual link below. Commands seem to be standard-ish, but even after adding the model number to the 'LK450_etc' group which at least le…
-
I am currently on Chapter 5. So the thing is I am using an Arduino (meaning using the m328p). I flash my arduino with the SerialLoopback code. I hook up a USB to TTL from my computer onto my Arduino.
…