-
After _much_ discussion (in #248 ), a minimal-version of a Servo class was added in release v1.3.0 of GpioZero.
However it doesn't include **everything** that people had been asking for, so this is a…
lurch updated
6 years ago
-
Nothing happens whenever i use Zmax or M5 Stop pins as servos. Only Bltouch works. But i need at least bltouch and another servo working.
I redefined pins and change num_servo to 2. no luck
-
Add servo presets so can be made straight horizontally with a click of a button (or otherwise)
-
Need to tune servo "on" time and also determine speed. Verify that it is the same under load.
Check that the delay loop doesn't mess with any of the other code.
-
```
What steps will reproduce the problem?
1.Write some arduino code useing '#include ' to use the servo library
which is available for the arduino uno (and more)
2.Hit compile
3.Watch the error mess…
-
```
Port.
```
Original issue reported on code.google.com by `GorillaCoder` on 25 Mar 2010 at 12:33
-
```
What steps will reproduce the problem?
1.Write some arduino code useing '#include ' to use the servo library
which is available for the arduino uno (and more)
2.Hit compile
3.Watch the error mess…
-
```
What steps will reproduce the problem?
1.Write some arduino code useing '#include ' to use the servo library
which is available for the arduino uno (and more)
2.Hit compile
3.Watch the error mess…
-
This is unreasonably long. The other mac builders take 18 minutes; servo-mac7 takes 28.
-
Test max torque of each servo to see at which position it should be installed and save data to compare again after one year. Also use it to calibrate servo internal force meassurement.
For this build…