-
First, thank you so much for your great work. It's very interesting to create your own sensors/actuators.
I bought two waterproof sensors SHT30. But I cannot change the i2c address and I cannot acc…
-
### PROBLEM DESCRIPTION
_A clear and concise description of what the problem is._
I have an air quality sensor that uses a Senseair S8 CO2 sensor. The sensor is detected correctly when the dev…
-
### PROBLEM DESCRIPTION
Attached a SHT30 sensor inside a thermocouple for high humidity to a ESP8266 board. I am using the latest Tasmota 11.0.0.2 by Theo Arends. Followed Wiki Article [https://www…
-
section4 の配線図が MOSFET に GND が配線されてないという指摘を受けました。その通りです!
https://tutorial.chirimen.org/raspi/section4#section-4
https://github.com/chirimen-oh/chirimen.org/blob/master/raspi/imgs/section4/schematic…
-
Hi! I wrote here in past about issues on parallel use of a E32900t20d and a SHT30 (they use I2C), I solved using I2C on others declared PINs.
My issue now is about the packet transmission structure.
…
-
This may be a node-red inexperience issue but would appreciate any assistance.
I have contact sensors reporting into node-red via mqtt, works well. I have node-red-smartthings installed, simulator …
-
I have recently been using an [ESP32 S2 LOLIN S2 mini](https://www.wemos.cc/en/latest/s2/s2_mini.html).
I used the [sensirion arduino-sht](https://github.com/Sensirion/arduino-sht) library for sht30 …
-
### PROBLEM DESCRIPTION
_A clear and concise description of what the problem is._
I try to get readings from my Wemos SHT30 Shield V2.0.0 but it is not detected by my Wemos D1 mini board. I am u…
-
**Describe the bug**
Dendrometer had a 6 week deployment and in their code, they measured the Vbat pin through the Analog module. The values for all of the devices had a battery voltage starting from…
-
See [forum request](https://www.letscontrolit.com/forum/viewtopic.php?p=51510#p51510)
Playground P178_SCD30.
TD-er updated
2 years ago